Anycubic Resin Funnel 3D Models for Pouring and Filtering Accessories

What do you deal with the resin left in vat after each print? Do you directly pour back into the resin bottle? Please don't do that, because not only will it be the main reason for your next print failure, but also ruin the fragile FEP film.

In this article, you can see two multifunctional funnel 3D models designed by Anycubic, and how to use them to do with the rest of resin after print.

Resin funnels and pouring accessories for Anycubic

Download now: Anycubic Resin Funnel STL files

How to Filter Your Resin with Anycubic Funnel 3D Models

Tools You Need

  • Printed Funnel
  • Paper Strainer
  • Clean Gloves
  • Paper Towels

Step 1: Wear clean gloves, and cap the funnel tightly over the resin bottle.

Step 2: Put the filter paper on the funnel.

Step 3: Pour and scrape off all the resin from the tank.

Step 4: Wipe the funnel with paper towels.

cap the funnel over the bottle

(step1)

Pour all the resin from tank

(step2-step3)

Caution:Before throwing away these tools, such as paper towels, funnels, strainers, gloves or anything that got liquid resin, please put them out in the sun or Anycubic Wash & Cure Machine for a full UV cure until they are completely dry.

Why We Recommend Anycubic Funnel 3D Models

1. Avoid leakage and a mess — the pointed diversion port on the top and the cap on the bottom keep the resin bottle clean when pouring resin, moreover the funnel with a the bottom cap 100% fits both Anycubic 500g&1000g Resin Bottles.

2. Easy to use — the funnel acts as a sturdy base, holding the paper strainer inside to prevent spilling or tip over, while effectively filtering small pieces of cured resin hidden in the vat.

3. Save cost — save about $1, each time uncured resin is filtered from the tank for reuse.

pointed diversion port design

Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.